Allworx 9202 User's Guide download pdf (Page 5)

Phone Guide – 9202E

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

owners.

Revised: May 30, 2012

Page 1

1 Getting Started

1.1 What is in the box?

Check the contents of the box your phone came in. You should have:

• Allworx 9202E phone and base

• Handset with cord

• Phone Functions Reference Card

• A Quick Start Guide

Not included but also needed:

• Ethernet cable to connect the phone to the network

• Power supply: 24VDC, 400 mA (or a network connection with Power over Ethernet)

1.2 Connecting the Phone

Allworx 9202E handsets are compatible with Allworx server software release 7.4 and higher. Do not attempt to

install a 9202E on a server that is running a lower version of software.

Follow these steps to connect your phone (see the figure below):

1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.

See icon on back of phone:

2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end

into your Ethernet jack on the wall.

WARNING: Do not connect to an analog phone line.

3. A computer may be connected to the network through the phone’s Computer jack.

4. If you are using Power over Ethernet (PoE), the power to the phone was supplied when you connected

the Ethernet cable. If this is the case, skip to step 6.

5. If you are not using PoE, obtain a power supply, connect the power cable to the phone, and then plug

the other end into an outlet. It’s a good idea to use a surge protector.

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Allworx 9202 User's Guide Page 5