CAUTION: If the network connection between the Px and the Allworx
server is interrupted, regular use of the Px's FXO and FXS ports will not be
possible. The only option for placing calls through a Px that does not have
a functional network connection to its Allworx server is to plug an analog
phone into the Power Fail port. Calls placed using this phone will be routed
to the CO line connected to FXO port 1. No other ports will be functional.
Refer to the Allworx Px 6/2 Expander Installation Guide or to the Remote
Installation FAQ for remote installation instructions.
-When the remotely registered Allworx Px 6/2 Expander is behind a
firewall, what IP ports must be configured for the Expander to work
properly?
For the Px to work properly, the following ports must be forwarded through
the firewall:
2088 (UDP) 5060 (UDP) 8081 (TCP) 15000-15511 (UDP)
-How do I configure the Allworx Px 6/2 Expander’s CO and analog
phone lines?
Once the Px unit is set up on the network, you can add lines and change
line settings from the Allworx server admin page. Go to Phone System >
Outside Lines and Phone System > Handsets. Refer to the Allworx
System Administrator's Guide (6.9.2.x) for instructions.
-How do I configure the Allworx Px 6/2 Expander’s SIP settings?
Once the Px unit is set up on the network, you can modify the SIP
settings from the server admin page. Go to Network > Port Expanders.
Refer to the Allworx System Administrator's Guide (6.9.2.x) for
instructions.
-How do I configure the Allworx Px 6/2 Expander’s network
settings?
If the Px is on the same network as the Allworx server and if the Allworx
server is the DHCP server for the site's network, no network settings have
to be configured. Just plug it into the site's network and power it up! If the
Allworx server is in LAN Host Mode and is not the site's DHCP server, refer
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals