Allworx 24X Installation Guide download pdf (Page 12)

24x Installation Guide

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

trademarks or registered trademarks of their respective owners.

Revised: February 7, 2007

Page 9

5 Electrical

5.1 Power Connection

Warning: Failure to follow these steps may result in equipment damage, personal injury, and a voided

product warranty.

Insert the female end of the power cord into the receptacle on the rear of the unit. Connect the other end to

the power source. The product is rated 115/230 VAC, 1/0.7A, and 50/60Hz. The Allworx server will

automatically begin to power up once the power has been stable for a few seconds. This is part of the design

to automatically boot up after a power failure.

5.2 Chassis Ground

Warning: Failure to follow these steps may result in equipment damage, personal injury, and a voided

product warranty.

To help prevent electrical shock, the separate protective earthing terminal, located next to the power jack on

the rear panel, must be permanently connected to earth using 18 AWG wire or larger. (See

Figure 2, item 13)

5.3 Power-Up Sequence

As the Allworx server progresses through the power up sequence, the front panel lights will respond as shown

Table 2.

Front Panel Light Power-Up Sequence Description

Power

Flashes green as the power up sequence

progresses; steady green when the unit is ready.

Activity – HD

Solid green when drive mounted; blinking light

indicates activity.

Activity – USB

Solid green when device attached and enabled;

blinking light indicates activity.

Table 2: Front Panel Lights During Power-Up Sequence

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Allworx 24X Installation Guide Page 12