Allworx Px 6/2 Installation Guide download pdf (Page 5)

it reboots while connected to the server.

-Where can I get the latest installation instructions for the Allworx

Px 6/2 Expander?

A copy of the guide is packaged with each Px. The latest version of the

guide can be downloaded from the Allworx Partner Portal, under Support &

Training > Documentation. Setup of the Px's FXO and FXS ports is done

through the Allworx server admin page. Instructions are found in the

Allworx Server Administrator's Guide (6.9.2.1 or higher), also available on

the Allworx Partner portal.

-What types of CO lines are supported by the Allworx Px 6/2

Expander?

Any standard Loop Start CO lines from a Telco or IAD can be used on the

Px.

-What are the Allworx Px 6/2 Expander’s Ethernet Port

Characteristics?

There is a single Ethernet port for connecting the Px to the site's network.

It is an auto-sensing 10/100 Mbps port.

-Can the Allworx Px 6/2 Expander be connected remotely? If so,

how are 911 calls handled?

Remote connection of Port Expanders is supported. However, the following

very important cautions must be taken into account:

CAUTION: Correct routing of 911 emergency calls for analog handsets

attached to remote Allworx Port Expanders cannot be guaranteed. Do not

use the Px's FXS ports for handsets from which placing 911 calls may be

attempted.

911 calls placed from a handset connected to an Allworx Px will be routed

using the service rule on the Allworx server. In most cases this will cause

the call to be placed using a line from the server site. The 911 call will

indicate the server site's address to the 911 dispatcher NOT the address of

the remote site. This can result in 911 not being able to route the

emergency response to the correct location.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Allworx Px 6/2 Installation Guide Page 5